Volume 10, Issue 3 (September 2013)                   IJMSE 2013, 10(3): 32-43 | Back to browse issues page

XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

H. Mohammadi, M. Ketabchi. INVESTIGATION OF MICROSTRUCTURAL AND MECHANICAL PROPERTIES OF 7075 AL ALLOYPREPARED BY SIMA METHOD. IJMSE 2013; 10 (3) :32-43
URL: http://ijmse.iust.ac.ir/article-1-572-en.html
Abstract:   (18355 Views)
The microstructure and mechanical properties of 7075 wrought aluminum alloy produced by strain induced melt activation (SIMA) route were investigated.Also liquid volume fraction measurement was studied by three procedures. Remelting process was carried out in the range of 560 to 610 °C for 20 min holding. The microstructure in the semi-solid state consists of fine spherical solid grains surrounded byliquid.The mechanical properties of the alloy vary with the grain size and weak mechanical properties of globular samples would appear if an alloy reheated at a high temperature. Thermodynamic simulation is a fast and efficient tool for the selection of alloys suitable for semi-solid processing
Full-Text [PDF 706 kb]   (6267 Downloads)    
Type of Study: Research Paper |

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 All Rights Reserved | Iranian Journal of Materials Science and Engineering

Designed & Developed by : Yektaweb