Hussain F, Manzoor M U, Kamran M, Ahmad T, Riaz F, Mukhtar S, et al . Optimizing Biocompatibility of Mg-AZ31B Alloy Through Varied Surface Roughness and Anodization Time. IJMSE 2024; 21 (3) :1-15
URL:
http://ijmse.iust.ac.ir/article-1-3669-en.html
Abstract: (3186 Views)
Magnesium alloys are increasingly valued for biomedical applications due to their biocompatibility. This study investigates Mg-AZ31B alloy samples treated with quartz and alumina grits (<200 μm) at varied pressures, followed by anodization in an eco-friendly alkaline electrolyte. The results show that increased blasting pressure produces a rougher surface. Anodization time significantly affects the thickness of the anodic film, leading to a transition in surface morphology from fine to coarse structures with complete film coverage. Characterization by XRD reveals that the anodic film mainly comprises magnesium oxide and hydroxide phases. Open Circuit Potential (OCP) measurements demonstrate enhanced corrosion resistance post-anodization, particularly notable at 40 minutes on alumina-blasted samples. ANOVA confirms that both blasting pressure and anodization time significantly influence coating thickness and OCP, indicating the formation of a dense anodized layer.
Full-Text [PDF 1507 kb]
(642 Downloads)
Highlights
- Increased blasting pressure results in higher surface roughness.
- Alumina-blasted samples show greater roughness and coating thickness than other abrasives.
- Detailed statistical analysis confirms proportionality between coating thickness, surface roughness, and deposition time.
- Optimized the anodizing process for magnesium alloys, leading to enhanced corrosion resistance and improved biocompatibility.