Volume 32, Issue 3 (IJIEPR 2021)                   IJIEPR 2021, 32(3): 1-13 | Back to browse issues page


XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Kaladhar M, Sameer Chakravarthy V, Chowdary P. Prediction of surface roughness using a novel approach. IJIEPR 2021; 32 (3) :1-13
URL: http://ijiepr.iust.ac.ir/article-1-1192-en.html
1- Department of Mechanical Engineering, Raghu Engineering College, Visakhapatnam, Andhra Pradesh, India , kaladhar2k@gmail.com
2- Department of Electronic and Communication Engineering, Raghu Institute of Technology, Visakhapatnam, Andhra Pradesh, India
Abstract:   (2047 Views)
Surface quality is a technical prerequisite in the field of manufacturing industries and can be treated as a quality index for machined parts. Attainment of appropriate surface finish plays a key role during functional performance of machined part. It is typically influenced by the machining parameters. Consequently, enumerating the good relation between surface roughness (Ra) and machining parameters is a highly focused task. In the current work, response surface methodology (RSM) based regression models and flower pollination algorithm (FPA) based sparse data model were developed to predict the minimum value of surface roughness in hard turning of AISI 4340 steel (35 HRC) using a single nanolayer of TiSiN-TiAlN PVD-coated cutting insert. The results obtained from this approach had good harmony with experimental results, as the standard deviation of the estimated values was simply 0.0804 (for whole) and 0.0289 (for below 1 µm Ra). When compared with RSM models, the proposed FPA based model showed the least percentage of mean absolute error. The model obtained the strongest correlation coefficient value of 99.75% among the other models values. The behavior of machining parameters and its interaction against surface roughness in the developed models were discussed with Pareto chart. It was observed that the feed rate was highly significant parameter in swaying machining surface roughness. In inference, the FPA sparse data model is a better choice over the RSM based regression models for prognosis of surface roughness in hard turning of AISI 4340 steel (35 HRC). The model developed using FPA based sparse data for surface roughness during hard turning operation in the current work is not reported to the best of author’s knowledge. This model disclosed a more dependable estimation over the multiple regression models.
Full-Text [PDF 831 kb]   (1136 Downloads)    
Type of Study: Research | Subject: Manufacturing Process & Systems
Received: 2021/01/11 | Accepted: 2021/07/19 | Published: 2021/06/9

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.