Y. Damchi, J. Sadeh, H. Rajabi Mashhadi,
Volume 11, Issue 2 (6-2015)
Abstract
The aim of the relay coordination is that protection systems detect and isolate the faulted part as fast and selective as possible. On the other hand, in order to reduce the fault clearing time, distance protection relays are usually equipped with pilot protection schemes. Such schemes can be considered in the distance and directional overcurrent relays (D&DOCRs) coordination to achieve faster protection systems, while the selectivity is maintained. Therefore, in this paper, a new formulation is presented for the relay coordination problem considering pilot protection. In the proposed formulation, the selectivity constraints for the primary distance and backup overcurrent relays are defined based on the fault at the end of the transmission lines, rather than those at the end of the first zone of the primary distance relay. To solve this nonlinear optimization problem, a combination of genetic algorithm (GA) and linear programming (LP) is used as a hybrid genetic algorithm (HGA). The proposed approach is tested on an 8-bus and the IEEE 14-bus test systems. Simulation results indicate that considering the pilot protection in the D&DOCRS coordination, not only obtains feasible and effective solutions for the relay settings, but also reduces the overall operating time of the protection system.
Y. Damchi, J. Sadeh, H. Rajabi Mashhadi,
Volume 11, Issue 3 (9-2015)
Abstract
Most studies in relay coordination have focused solely on coordination of overcurrent relays while distance relays are used as the main protection of transmission lines. Since, simultaneous coordination of these two types of relays can provide a better protection, in this paper, a new approach is proposed for simultaneous coordination of distance and directional overcurrent relays (D&DOCRs). Also, pursued by most of the previously published studies, the settings of D&DOCRs are usually determined based on a main network topology which may result in mis-coordination of relays when changes occur in the network topology. In the proposed method, in order to have a robust coordination, network topology changes are taken into account in the coordination problem. In the new formulation, coordination constraints for different network topologies are added to those of the main topology. A complex nonlinear optimization problem is derived to find the desirable relay settings. Then, the problem is solved using hybridized genetic algorithm (GA) with linear programming (LP) method (HGA). The proposed method is evaluated using the IEEE 14-bus test system. According to the results, a feasible and robust solution is obtained for D&DOCRs coordination while all constraints, which are due to different network topologies, are satisfied.

Seyed Masoud Barakati, Farzad Tahmasebi,
Volume 19, Issue 3 (9-2023)
Abstract
Increasing the penetration of distributed generation (DG) systems in power systems has many advantages, but it also has problems, including interference with the proper functioning of the protection systems. This problem is severe in microgrid systems that contain many DGs. Overcurrent relays are one of the most critical protection equipment of protection systems. The DG sources significantly change the characteristics of fault currents and the protection designs as well as the coordination of overcurrent relays. This paper proposes a coordination method for directional overcurrent relays with dual adjustment to resolve the interference problem in the protection system of a microgrid in the presence of distributed generation sources based on the electronic power converter (inverter). This is done by considering the curve of different standard characteristics according to the IEC60255 standard in two operating modes, the grid-connected and islanded. A genetic optimization algorithm is used to reduce the total operating time of the relays. The simulation results verify the effectiveness of the proposed coordination method. The results show that the protection coordination scheme with dual adjustment relays and the use of combined characteristic curves can significantly reduce the operating time of the total relays.