Showing 3 results for H-Bridge
S. R. Sadu, P. V. Prasad, G. N. Srinivas,
Volume 14, Issue 1 (3-2018)
Abstract
This paper presents the comparative study of three phase twenty five level diode clamped and cascaded H-bridge multilevel inverters. The comparison is made in respect of requirement of devices, quality of output voltage and reduction of total harmonic distortion at the multilevel inverter terminals. In this work multicarrier sinusoidal pulse modulation control methods of Phase disposition (PD-PWM), phase opposition disposition (POD-PWM) and Alternative Phase Opposition Disposition (APOD-PWM) pulse width modulation control strategies are applied for both diode clamped and cascaded H-bridge multilevel inverters and compared its total harmonic distortion. The performance of both diode and cascaded H-bridge multilevel inverters is investigated and compared. Based on simulation results it is observed that the output voltage of the cascaded H-bridge multilevel inverters is better as compared to the diode clamped multilevel inverter. The proposed multilevel inverters are simulated using MATLAB/Simulink software.
Oorappan G Murugan, Jeevanandham Arumugam, Suresh Velliangiri,
Volume 19, Issue 4 (12-2023)
Abstract
Single Source Cross Connected Reduced Activated Switched-Capacitor Multilevel Inverter (S2C2RASCMLI) accompanied by fewer active switching components is appealing to nine-level of voltage with its simplicity and a solid network. In AC power distribution systems, multi-level inverters are used as DC-to-AC converter operations to achieve the desired output magnitude and frequency. It is employed for the smooth operation of electrical machines. The proposed S2C2RASCMIL cell yields a nine-level voltage with ten switches, nine driver signals, and two flying capacitors for dynamic load operation with reduced active switches. It has the capability of boosting the input voltage double the times. The proposed multilevel inverter operated on nine switching modes and in each mode, three switches have been conducted. It can be extended horizontal and/or vertical structure to produce more levels of output voltages. The hardware prototype was made and the results have been presented. To demonstrate the advantages of the new proposed multilevel inverter topology, a comprehensive comparison with a few other similar multilevel inverter configurations is done. Analysis and simulation output waveforms for a variety of load conditions were tested to check the feasibility of the proposed new multi-level inverter. The proposed MLI offers better performance than existing multilevel inverters.
Ying Foo Leong, Nizaruddin M. Nasir, Suliana Ab-Ghani, Norazila Jaalam, Nur Huda Ramlan,
Volume 21, Issue 2 (6-2025)
Abstract
This paper focuses on the application of a cascaded multilevel inverter, specifically the 5-level multilevel inverter, utilizing a proposed controller known as the FLC-PSO-PI controller. The primary challenge addressed in this research is the precise regulation of output voltage in the multilevel inverter during load variations while meeting voltage harmonic and transition requirements as per industry standards, which are the 10 % voltage limit recommended by IEC and 8 % of total harmonic distortion (THD) by IEEE. An innovative solution is proposed by integrating PSO and FLC to dynamically adapt the controller in real-time, ensuring stable and accurate output voltage regulation. The proposed controller is designed and simulated using MATLAB/Simulink, and its performance is compared with PSO-PI and no controller under various load conditions. The results demonstrate that the FLC-PSO-PI controller significantly enhances output voltage regulation were achieving the desired peak voltage and low THD across different load scenarios, including half load to full load (0.8 %) and no load to full load (0.89 %). Furthermore, the FLC-PSO-PI controller exhibits superior transient response characteristics, such as reduced overshooting (2.89 %), faster rise time at 36.946 µs, and satisfactory settling time at 151.014 µs. This research contributes to the advancement of multilevel inverter technology and its potential applications in renewable energy systems, motor drives, and grid-connected devices. The proposed FLC-PSO-PI controller offers a promising solution for precise voltage regulation in multilevel inverters, enhancing their performance and enabling widespread adoption in various industrial sectors.
