A. Paykani, R. Khoshbakhti Saray, A. M. Mohammadi Kousha, M. T. Shervani Tabar,
Volume 1, Issue 2 (6-2011)
Abstract
In this study, a numerical simulation using the CFD software, FLUENT, has been conducted to examine the effect of various shapes of the venturi component sections in order to find the optimum venturi specifications to increase the EGR rate with minimum pressure loss at the part load operation range. The CFD results reveal that the venturi should be precisely optimized to introduce the required amount of EGR to the engine manifold. Then, the optimum venturi was manufactured, and it was installed on the engine intake system. By using the optimum Venturi EGR system instead of original system the 26% increase in EGR flow rate to the engine manifold is observed. In the second part of the paper, an experimental investigation was carried out on a “Lister 8-1” dual fuel (diesel – natural gas) engine to examine the simultaneous effect of inlet air pre-heating and EGR on performance and emission characteristics of a dual fuel engine. The use of EGR at high levels seems to be unable to improve the engine performance at part loads, however, it is shown that EGR combined with pre-heating of inlet air can slightly increase thermal efficiency, resulting in reduced levels of both UHC and NOx emissions. CO and HC emissions were reduced by 24% and 31%, respectively. The NOx emissions were decreased by 21% because of the lower combustion temperature due to the much inert gas brought by EGR and decreased oxygen concentration in the cylinder.
A.h Kakaee, P. Rahnama, A. Paykani,
Volume 4, Issue 3 (9-2014)
Abstract
In this paper, a numerical study is performed to provide the combustion and emission characteristics resulting from fuel-reactivity controlled compression ignition (RCCI) combustion mode in a heavy-duty, single-cylinder diesel engine with gasoline and diesel fuels. In RCCI strategy in-cylinder fuel blending is used to develop fuel reactivity gradients in the combustion chamber that result in a broad combustion event and reduced pressure rise rates (PRR). RCCI has been demonstrated to yield low NOx and soot with high thermal efficiency in light and heavy-duty engines. KIVA-CHEMKIN code with a reduced primary reference fuel (PRF) mechanism are implemented to study injection timings of high reactivity fuel (i.e., diesel) and low reactivity fuel percentages (i.e., gasoline) at a constant engine speed of 1300 rpm and medium load of 9 bar indicated mean effective pressure (IMEP). Significant reduction in nitrogen oxide (NOx), while 49% gross indicated efficiency (GIE) were achieved successfully through the RCCI combustion mode. The parametric study of the RCCI combustion mode revealed that the peak cylinder pressure rise rate (PPRR) of the RCCI combustion mode could be controlled by several physical parameters – PRF number, and start of injection (SOI) timing of directly injected fuel.