Volume 4, Issue 3 (9-2014)                   ASE 2014, 4(3): 758-768 | Back to browse issues page

XML Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Das S, Nayak R, Dhupal D, Kumar A. Surface Roughness, Machining Force and FlankWear in Turning of Hardened AISI 4340 Steel with Coated Carbide Insert: Cutting Parameters Effects. ASE 2014; 4 (3) :758-768
URL: http://www.iust.ac.ir/ijae/article-1-275-en.html
Abstract:   (22724 Views)
The current experimental study is to investigate the effects of process parameters (cutting speed, feed rate and depth of cut) on performance characteristics (surface roughness, machining force and flank wear) in hard turning of AISI 4340 steel with multilayer CVD (TiN/TiCN/Al2O3) coated carbide insert. Combined effects of cutting parameter (v, f, d) on performance outputs (Ra, Fm and VB) are explored employing the analysis of variance (ANOVA). An L9 Taguchi standard design of experiments procedure was used to develop the regression models for machining responses, within the range of parameters selected. Results show that, feed rate has statistical significance on surface roughness and the machining force is influenced principally by the feed rate and depth of cut whereas , cutting speed is the most significant factor for flank wear followed by cutting speed. The desirability function approach has been used for multi-response optimization. Based on the surface roughness, machining force and flank wear, optimized machining conditions were observed in the region 147 m/min cutting speed and 0.10 mm/rev feed rate and 0.6 mm depth of cut.
Full-Text [PDF 235 kb]   (6727 Downloads)    

Add your comments about this article : Your username or Email:
CAPTCHA

Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2022 All Rights Reserved | Automotive Science and Engineering

Designed & Developed by : Yektaweb