Search published articles

Showing 2 results for Design of Experiments

M. Abbasi, R. Kazemi, A. Ghafari Nazari,
Volume 1, Issue 3 (5-2011)

Parametric design optimization of an automotive body crashworthiness improvement is presented. The thicknesses of parts are employed as design variables for optimization whose objective is to increase the maximum deceleration value of the vehicle center of gravity during an impact. Using the Taguchi method, this study analyzes the optimum conditions for design objectives and the impact factors and their optimal levels are obtained by a range analysis of the experiment results. A full frontal impact is implemented for the crashworthiness simulation in the nonlinear dynamic code, LS-DYNA. The controllable factors used in this study consist of the six inside foreheads structural parts, while design parameters are relevant thicknesses. The most interestingly the maximum deceleration of the vehicle center of gravity is reduced by 20% during a full frontal impact while several parts experience mass reduction.
Masoud Afrousheh, Javad Marzbanrad, Sanaz Abdollahzadeh,
Volume 9, Issue 4 (12-2019)

Thin-walled structures play an important role in absorbing the energy in a low impact crash of vehicles up to saving lives from high impact Injury. In this paper, the thin-walled columns by using a hybrid Design of Experiments (DOE) and Ant Colony Algorithm (ACO) has been optimized. The analysis of the behavior of the nonlinear models under bending load is done using finite-element software Abaqus. The objective is to study the performance geometrically parameters of the columns using DOE-ACO approach.
DOE method is being applied to determine the effects of cross-sections, material, and thickness on the energy absorption; and the ACO method is used for finding more accurate thickness on energy absorption. Four types of thin-walled cross-sections, i.e., circle, ellipse, hexagon, and square are used in this study. The optimized results of DOE method show that aluminum alloy (Al-6061) and high strength low alloy steel (HSLA) square columns have a higher energy absorption in comparison with the other cross-sections. However, the amount of absorbed energy in two types of columns is equal but, 50 percent weight reduction may be seen in Al-6061 columns. The columns are re-optimized by ACO to find the best thickness in the last step.
In the following, by topology optimization participation, a new plan is proposed by the same thickness and 50% less weight, that has a higher crashworthiness efficiency by increasing SAE more than 70%. As a result of this plan is bridging the gap between standard topological design and multi-criteria optimization.

Page 1 from 1     

© 2022 All Rights Reserved | Automotive Science and Engineering

Designed & Developed by : Yektaweb