Search published articles


Showing 3 results for Repair

Saffar Zadeh M., Karbasi Zadeh B.,
Volume 2, Issue 1 (3-2004)
Abstract

In this paper, optimal bridge management system models have been presented. These optimization models are capable of allocating limited resources to the bridge preservation schemes in order to establish the optimal time of completing the activities. Bridge-based activities are divided into two main groups: repair projects, and maintenance activities and both models are presented in this paper. Particular attention has been made to optimize the management of the two system activities. The dynamic programming approach was utilized to formulate and analyze the two models. The developed models are found to be more accurate and faster than the previous ones.
S. Eshghi, V. Zanjanizadeh,
Volume 5, Issue 3 (9-2007)
Abstract

This paper presents an experimental study on seismic repair of damaged square reinforced concrete columns with poor lap splices, 90-degree hooks and widely spaced transverse bars in plastic hinge regions according to ACI detailing (pre.1971) and (318-02) using GFRP wraps. Three specimens were tested in “as built” condition and retested after they were repaired by glass fiberreinforced plastic sheets. They were tested under numerous reversed lateral cyclic loading with a constant axial load ratio. FRP composite wraps were used for repairing of concrete columns in critically stressed areas near the column footings. Physical and mechanical properties of composite wraps are described. Seismic performance and ductility of the repaired columns in terms of the hysteretic response are evaluated and compared with those of the original columns. The results indicated that GFRP wraps can be an effective repair measure for poorly confined R/C columns due to short splice length and widely spaced ties with 90-degree anchorage hooks. Both flexural strength and ductility of repaired columns were improved by increasing the existing confinement in critical regions of them.
A. Ahmed A, S. Naganathan, K. Nasharuddin, M.m. Fayyadh,
Volume 13, Issue 2 (6-2015)
Abstract

The effect of steel plate thickness on the repair effectiveness of RC beam is presented in this paper. A total of four beams were tested, one beam repaired by CFRP with a thickness of 1.2 mm and used as a control beam, and three beams repaired by a steel plate. Steel plates with a thickness of 2 mm, 3 mm, and 4 mm were used in repairing the beams. The maximum load-carrying capacity, deflection at mid span and edge of the opening, strain in steel bars, strain in externally bonded plates, crack patterns, and failure modes were observed on each beam. The externally bonded CFRP sheet and steel plates were found to be effective in the repairing of RC beams with large rectangular web opening. The results show that increasing steel plate thickness has little effect on the maximum load capacity. The CFRP plate is more effective than steel plate in increasing the load capacity of beams.

Page 1 from 1     

© 2021 All Rights Reserved | International Journal of Civil Engineering

Designed & Developed by : Yektaweb