Search published articles


Showing 7 results for Moghaddas Tafreshi

S.n. Moghaddas Tafreshi, Gh. Tavakoli Mehrjardi, S.m. Moghaddas Tafreshi,
Volume 5, Issue 2 (June 2007)
Abstract

The safety of buried pipes under repeated load has been a challenging task in geotechnical engineering. In this paper artificial neural network and regression model for predicting the vertical deformation of high-density polyethylene (HDPE), small diameter flexible pipes buried in reinforced trenches, which were subjected to repeated loadings to simulate the heavy vehicle loads, are proposed. The experimental data from tests show that the vertical diametric strain (VDS) of pipe embedded in reinforced sand depends on relative density of sand, number of reinforced layers and height of embedment depth of pipe significantly. Therefore in this investigation, the value of VDS is related to above pointed parameters. A database of 72 experiments from laboratory tests were utilized to train, validate and test the developed neural network and regression model. The results show that the predicted of the vertical diametric strain (VDS) using the trained neural network and regression model are in good agreement with the experimental results but the predictions obtained from the neural network are better than regression model as the maximum percentage of error for training data is less than 1.56% and 27.4%, for neural network and regression model, respectively. Also the additional set of 24 data was used for validation of the model as 90% of predicted results have less than 7% and 21.5% error for neural network and regression model, respectively. A parametric study has been conducted using the trained neural network to study the important parameters on the vertical diametric strain.
S.n. Moghaddas Tafreshi, A. Asakereh,
Volume 5, Issue 4 (December 2007)
Abstract

Conventional investigations on the behavior of reinforced and unreinforced soils are often investigated at the failure point. In this paper, a new concept of comparison of the behavior of reinforced and unreinforced soil by estimating the strength and strength ratio (deviatoric stress of reinforced sample to unreinforced sample) at various strain levels is proposed. A comprehensive set of laboratory triaxial compression tests was carried out on wet (natural water content) non-plastic beach silty sand with and without geotextile. The layer configurations used are one, two, three and four horizontal reinforcing layers in a triaxial test sample. The influences of the number of geotextile layers and confining pressure at 3%, 6%, 9%, 12% and 15% of the imposed strain levels on sample were studied and described. The results show that the trend and magnitude of strength ratio is different for various strain level. It implies that using failure strength from peak point or strength corresponding to the axial-strain approximately 15% to evaluate the enhancement of strength or strength ratio due to reinforcement may cause hazard and uncertainty in practical design. Hence, it is necessary to consider the strength of reinforced sample compared with unreinforced sample at the imposed strain level. Only one type of soil and one type of geotextile were used in all tests.
S. N. Moghaddas Tafreshi,
Volume 6, Issue 4 (December 2008)
Abstract

This paper presents the numerical analysis of seismic soil-pile-superstructure interaction in soft clay using free-field soil analysis and beam on Winkler foundation approach. This model is developed to compute the nonlinear response of single piles under seismic loads, based on one-dimensional finite element formulation. The parameters of the proposed model are calibrated by fitting the experimental data of largescale seismic soil-pile-structure tests which were conducted on shaking table in UC Berkeley. A comparative evaluation of single piles shows that the results obtained from the proposed procedure are in good agreement with the experimental results.
S. N. Moghaddas Tafreshi, Gh. Tavakoli Mehrjardi, M. Ahmadi,
Volume 9, Issue 4 (December 2011)
Abstract

The results of laboratory model tests and numerical analysis on circular footings supported on sand bed under incremental

cyclic loads are presented. The incremental values of intensity of cyclic loads (loading, unloading and reloading) were applied

on the footing to evaluate the response of footing and also to obtain the value of elastic rebound of the footing corresponding

to each cycle of load. The effect of sand relative density of 42%, 62%, and 72% and different circular footing area of 25, 50,

and 100cm2 were investigated on the value of coefficient of elastic uniform compression of sand (CEUC). The results show that

the value of coefficient of elastic uniform compression of sand was increased by increasing the sand relative density while with

increase the footing area the value of coefficient of elastic uniform compression of sand was decreases. The responses of footing

and the quantitative variations of CEUC with footing area and soil relative density obtained from experimental results show a

good consistency with the obtained numerical result using “FLAC-3D”.


A. Asakereh, S.n. Moghaddas Tafreshi, M. Ghazavi,
Volume 10, Issue 2 (June 2012)
Abstract

This paper describes a series of laboratory model tests on strip footings supported on unreinforced and geogrid-reinforced sand
with an inside void. The footing is subjected to a combination of static and cyclic loading. The influence of various parameters
including the embedment depth of the void, the number of reinforcement layers, and the amplitude of cyclic load were studied.
The results show that the footing settlement due to repeated loading increased when the void existed in the failure zone of the
footing and decreased with increasing the void vertical distance from the footing bottom and with increasing the reinforcement
layers beneath the footing. For a specified amplitude of repeated load, the footing settlement is comparable for reinforced sand,
thicker soil layer over the void and much improved the settlement of unreinforced sand without void. In general, the results
indicate that, the reinforced soil-footing system with sufficient geogride-reinforcement and void embedment depth behaves much
stiffer and thus carries greater loading with lower settlement compared with unreinforced soil in the absent of void and can
eliminate the adverse effect of the void on the footing behavior. The final footing settlement under repeated cyclic loading becomes
about 4 times with respect to the footing settlement under static loading at the same magnitude of load applied.


S. N. Moghaddas Tafreshi, T. Nouri. A,
Volume 12, Issue 2 (Transaction B: Geotechnical Engineering April 2014)
Abstract

This paper presents a simple solution based on the limit equilibrium of sliding soil wedge of reinforced backfill subjected to the horizontal acceleration in the framework of the pseudo-static method. In particular, contrary to most studies on the reinforced retaining wall, the solution proposed in this study, takes into account the effect of the uniform surcharge on the reinforced backfill soil and of its distance from the face of the wall. The results are investigated in dimensionless form of the maximum reinforcement required strength (Kmax), the dimension of the sliding wedge (Lc/H), and the factor of safety (FS). Compared to the reinforced backfill without surcharge, the presence of surcharge over the reinforced backfill and of its distance from the top of the backfill have significant effects on the stability of the system. For a fixed surcharge, a minimum distance of surcharge exists for which the presence of the surcharge does not affect the solution and the failure mechanism is that corresponding to the case of system with no surcharge. A detailed design example is included to illustrate usage of proposed procedures. Comparisons of the present results with available results show a favorable agreement.
Dr. Gh. Tavakoli Mehrjardi, Prof. S.n. Moghaddas Tafreshi, Dr. A.r. Dawson,
Volume 13, Issue 2 (Transaction B: Geotechnical Engineering June 2015)
Abstract

A numerical simulation of laboratory model tests was carried out to develop an understanding of the behaviour of pipes in a trench prepared with 3-Dimensional reinforced (namely "geocell-reinforced" in the present study) sand and rubber-soil mixtures, under repeated loadings. The study reports overall performance of buried pipes in different conditions of pipe-trench installations and the influence of pipe stiffness on backfill settlements, stress distribution in the trench depth and stress distribution along the pipe's longitudinal axis. Good agreements between the numerical results and experimental results were observed. The results demonstrate that combined use of the geocell layer and rubber-soil mixture can reduce soil surface settlement and pipe deflection and eventually provide a secure condition for buried pipe even under strong repeated loads.

Page 1 from 1     

© 2018 All Rights Reserved | International Journal of Civil Engineering

Designed & Developed by : Yektaweb