Search published articles


Showing 2 results for Mix Design

A.a. Maghsoudi, Sh. Amohamadpour, M. Maghsoudi,
Volume 9, Issue 3 (9-2011)
Abstract

Considering normal concrete (NC) the type of concrete need to be vibrated after placing in the formwork, Lightweight

concretes have been successfully applied in the building constructions for decades because of their low specific weight in

connection with a high strength, a high capacity of thermal insulation and a high durability. The development leading to a self

compacting light weight concrete (SCLWC) represents an important innovative step in the recent years. This concrete combines

the favorable properties of a lightweight concrete with those of a self compacting concrete (i.e., the type of concrete need no

vibration after placing in the formwork). Research work is aimed on development of (SCLWC) with the use of light weight

aggregates " Light expand clay aggregate (Leca)". In this investigation, by trial and error procedure, different mix design of

SCLWC were caste and tested to reach a so called standard self compacting concrete in fresh matrix phase such as values of

slump flow, L-box, V-funnel and in hardened phase, the 28 day compressive strength. Based on the results obtained, for two best

so-called standard mix design of SCLWC the stress-strain diagrams are drawn and discussed. Also by three different methods,

the modulus of elasticity of SCLWC are obtained and discussed here. It was found that a brittle mode of failure is governed in

SCLWC.


S. Bakhtiyari, A. Allahverdi, M. Rais-Ghasemi, A. A. Ramezanianpour, T. Parhizkar, B. A. Zarrabi,
Volume 9, Issue 3 (9-2011)
Abstract

Self Compacting Concrete (SCC) specimens with limestone (L) and quartz (Q) powders were formulated. The influence of the type

of the powder on the properties of fresh and hardened concrete was evaluated. Dense packing theories were used for mix design

of samples. The equation of Fuller and Thompson for particle size distribution (PSD) of aggregates was modified with considering

fine particles and a proper PSD curve was obtained for SCC. Experimental results showed that this method needs use of less

powder content and results in higher strength/cement ratio compared to traditional mixing methods. No significant difference was

observed between the compressive strengths of specimens containing limestone (L-specimens) and quartz (Q-specimens) powders,

with similar proportions of materials. The residual compressive strength of specimens was examined at 500°C and contradictory

behaviors were observed. One Q-specimen suffered from explosive spalling, while no spalling was occurred for L-specimens. On

the other hand, the residual strength of remained Q-specimens showed considerable increase compared to L-specimens. The results

show the necessity for more detailed investigations considering different effective parameters.



Page 1 from 1     

© 2021 CC BY-NC 4.0 | International Journal of Civil Engineering

Designed & Developed by : Yektaweb