Search published articles


Showing 2 results for Naeini

S.a. Naeini, R. Ziaie-Moayed,
Volume 5, Issue 2 (June 2007)
Abstract

Series of undrained monotonic triaxial tests and cone penetration tests were conducted on loose silty sand samples to study correlation between undrained shear strength of silty sands (Sus) and piezocone test results. CPT tests were conducted at 27 silty sand samples in calibration chamber. The results indicate that, in low percent of silt (0-30%), as the silt content increases, the undrained shear strength (Sus) and cone tip resistance (qc) decreases. It is shown that, fines content affects undrained shear strength (Sus) and cone tip resistance (qc) similarly. On the basis of obtained results, equations were proposed to determine the normalized cone tip resistance (qc1n) and undrained shear strength (Sus) of silty sand in term of fines content. Finally based on those equations, a correlation between normalized cone tip resistance and undrained shear strength of silty sand is presented. It is shown that the normalized undrained shear strength and normalized cone tip resistance of loose silty sands (F.C. <30%) decreases with increase of silt contents.
S.a. Naeini, R. Ziaie_moayed,
Volume 7, Issue 2 (June 2009)
Abstract

In recent years, soil reinforcement is considered of great importance in many different civil projects. One of the most significant applications of soil reinforcement is in road construction. Sub grade soil and its properties are very important in the design of road pavement structure. Its main function is to give adequate support to the pavement from beneath. Therefore, it should have a sufficient load carrying capacity. The use of geosynthetics in road and airfield construction has shown the potential to increase the soil bearing capacity. One category of geosynthetics to particular, geogrid, has gained increasing acceptance in road construction. A geogrid is a geosynthetic material consisting of connected parallel sets of tensile ribs with apertures of sufficient size to allow strike-through of surrounding soil, stone, or other geotechnical material. Geogrid reinforcement of sub grade soil is achieved through the increase of frictional interaction between the soil and the reinforcement. Geogrid have been successfully used to provide a construction platform over subgrades. In this application, the geogrid improves the ability to obtain compaction in overlying aggregates, while reducing the amount of material required be removing and replacing. Relative agreement exists that substantial benefits can be achieved from the inclusion of geogrids within the pavement systems however, the quantity of the improvement is in relative disagreement. This paper presents the effects of plasticity index and also reinforcing of soft clay on CBR values. Three samples of clay with different plasticity index (PI) values are selected and tested without reinforcement. Then by placing one and two layer of geogrid at certain depth within sample height, the effects of reinforcement and PI on CBR values are investigated in both soaked and unsoaked conditions. The results shows that as the PI increase the CBR value decreases and reinforcing clay with geogrid will increase the CBR value.

Page 1 from 1     

© 2019 All Rights Reserved | International Journal of Civil Engineering

Designed & Developed by : Yektaweb