Search published articles


Showing 2 results for Haghbin

M. Haghbin,
Volume 12, Issue 4 (Transaction B: Geotechnical Engineering December 2014)
Abstract

This research examines the behavior of soil-reinforced piles and applied loads based on the analytical method and by using the numerical results of FLAC3D software for comparison with the analytical results. The analysis was based on a method called virtual retaining wall, the following into consideration: an imaginary retaining wall that passes the footing edge the bearing capacity of footing on reinforced soil with piles, which was determined by applying equilibrium between active and passive forces on virtual wall and a pile row that exists beneath the shallow foundation. To calculate the lateral pile resistance here, an analytical equation was then required. The main objective of this paper is to determine the percentage of applied load on pile. Similarly, the effect of adding pile in various positions relative to the present footing (underpinning) was studied in this research. The various parameters of this study included pile length, vertical distance of pile head to shallow footing, pile distance to center of footing and location of the pile. Finally, the findings were compared with the numerical results of FLAC3D and the formerly presented experimental results. Results show that the analytical method, while being close to other methods is more conservative.


Maryam Haghbin,
Volume 14, Issue 7 (Transaction B: Geotechnical Engineering 2016)
Abstract

In the present research, an analytical method is applied to determine the bearing capacity of strip footing on two layers of the soil. Bearing capacity of the footing is calculated according to soil resistance beneath the foundation and virtual retaining wall method. In the said method, the active and passive force on the retaining wall are considered equal on the edge in order to determine the bearing capacity of the footing. Regarding two layers of soil, the active and passive forces of each layer is found and their resultant is applied to calculate footing bearing capacity. This method has many advantages including the possibility to determine the depth of rupture surface of the soil beneath the footing, and to study the effect of the soil second layer on footing bearing capacity. Moreover, the effect of soil improvement beneath the footing as well as the depth and width of compacted area on bearing capacity of footing are also studied here in this research. In general, the studied parameters in this project consist of soil layers thickness, soil cohesion and friction angle, footing depth and width, the width of compacted soil beneath the footing, and the depth of underground water. By programming in MATLAB, the calculation and deduction was fulfilled. The results were compared with the bearing capacity of the footing on one layer of the soil in various situations in order to study the effect of various parameters in two layers of the soil. Finally, this bearing capacity of the footing was compared with the previous experimental methods and reliable results were obtained.



Page 1 from 1     

© 2019 All Rights Reserved | International Journal of Civil Engineering

Designed & Developed by : Yektaweb