دوره 10، شماره 2 - ( 4-1399 )                   جلد 10 شماره 2 صفحات 3209-3202 | برگشت به فهرست نسخه ها


XML English Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Kakaee A, Mahjoorghani M. Determining an efficient numerical solution method for pressure loss problem in bends. ASE 2020; 10 (2) :3202-3209
URL: http://www.iust.ac.ir/ijae/article-1-494-fa.html
Determining an efficient numerical solution method for pressure loss problem in bends. Automotive Science and Engineering. 1399; 10 (2) :3202-3209

URL: http://www.iust.ac.ir/ijae/article-1-494-fa.html


چکیده:   (11874 مشاهده)
Intake and exhaust manifolds are among the most important parts in engine in which pressure loss phenomena has direct impact on with changing volumetric efficiency. In typical 1D simulation codes, the quantity of pressure loss is proportional to the fluid’s mean velocity by Pressure Loss Coefficient (Kp) value. This important coefficient which has substantial rule in engine simulation is usually determined using constant available values, extracted from complicated experiments (like Miller’s tests) in a specified situation. But these values are credible only in situations according to those tests. Coupling 3D simulations with 1D codes is a common method to gain accurate values of these coefficients but this deals with drastic high simulation costs. To address this problem, a more efficient way is replacing an algebraic relation, extracted from 3D calculations, instead of a constant value in 1D code. It’s obvious that in order to reach accurate coefficients in arbitrary conditions (geometric and flow specifications) determining the best numerical method is mandatory.  In present research, after investigating all 3D simulation aspects, six different selected numerical solutions have been implemented on four different bends in ANSYS Fluent.Results have been validated by comparing loss coefficient values of incompressible fluid (water) with Miller loss coefficient values and method with the most accurate and stable results has been discovered. It was found that all these methods are suitable in general (with less than 5% error in coefficient values) but solutions with structured grid and SST k-ω turbulence modeling represented better stability and accuracy.
متن کامل [PDF 904 kb]   (6353 دریافت)    
نوع مطالعه: پژوهشي | موضوع مقاله: موتور احتراق داخلی

ارسال نظر درباره این مقاله : نام کاربری یا پست الکترونیک شما:
CAPTCHA

بازنشر اطلاعات
Creative Commons License این مقاله تحت شرایط Creative Commons Attribution-NonCommercial 4.0 International License قابل بازنشر است.

کلیه حقوق این وب سایت متعلق به مجله بین‌المللی مهندسی خودرو می باشد.

طراحی و برنامه نویسی : یکتاوب افزار شرق

© 2024 CC BY-NC 4.0 | Automotive Science and Engineering

Designed & Developed by : Yektaweb